Memmeddu
Member
- Messages
- 4,264
- Location
- Italia Sardegna
Hi everyone, I'm struggling to understand what's going on with my K770.
Just rebuilt the engine .
The saw starts and runs fine other than it throws the clutch off but I've put locktite and it should not happen again.
The problem happens at idle it will start to vibrate till it die and fuel comes out everywhere without stopping.
And if I open the air box I can see it's flooded, the main throttle body is submerged in fuel .
Can't understand why since the valve under the diaphragm works
What can cause this?
There's nothing I've assembled wrong.
Just rebuilt the engine .
The saw starts and runs fine other than it throws the clutch off but I've put locktite and it should not happen again.
The problem happens at idle it will start to vibrate till it die and fuel comes out everywhere without stopping.
And if I open the air box I can see it's flooded, the main throttle body is submerged in fuel .
Can't understand why since the valve under the diaphragm works
What can cause this?
There's nothing I've assembled wrong.