George88
New Member
- Messages
- 1
- Location
- Scotland
Hello
I got hold of a miller compactblu 243 mig for pretty cheap it looks to be 3 phase but inside the machine you can rearrange a few little plates around to get it to go from 415v to 240v (240v sounds about right as I’d be running the machine from home here in the uk ) but I’m not 100% is that correct to change that ? Also it’s a 3 phase machine but as above id like to run this from the house which is 1 phase I think ? The plugs are 13 amp and the machine says it needs 32 amp
Long story short (ish) lol what would I need to do to get this to work from my house
Thanks George
P.s I’m in no way good with electrics and all the other welders Iv had have just been 13amp 240v plug in and go , any help would be appreciated
I got hold of a miller compactblu 243 mig for pretty cheap it looks to be 3 phase but inside the machine you can rearrange a few little plates around to get it to go from 415v to 240v (240v sounds about right as I’d be running the machine from home here in the uk ) but I’m not 100% is that correct to change that ? Also it’s a 3 phase machine but as above id like to run this from the house which is 1 phase I think ? The plugs are 13 amp and the machine says it needs 32 amp
Long story short (ish) lol what would I need to do to get this to work from my house
Thanks George
P.s I’m in no way good with electrics and all the other welders Iv had have just been 13amp 240v plug in and go , any help would be appreciated