Any one used this lacquer ?

[Weldinator]

Has anyone used this stuff before > http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=270955091718&ssPageName=ADME:B:WNARL:GB:1123

Im thinking of using it around an area that the exhaust/manifold is where the heat shield does not protect from the heat.

 

[langy]

Has anyone used this stuff before > http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=270955091718&ssPageName=ADME:B:WNARL:GB:1123

Im thinking of using it around an area that the exhaust/manifold is where the heat shield does not protect from the heat.

Thats for the block (its crap by the way) so won't last in high heat situation.

 

[steveo3002]

thats more of a dressing than a paint finish , what youd do is clean all the engine down and mask off the wings then lash that all over everything to make it shine

 

[Weldinator]

Its not for the engine, its for a little area thats been stonechipped and 1k painted, in between the two heat shields. I want to try some protection so the paint wont degrade and then rust starting to start because of it.

Lacquer all in all seems not very good when it comes to heat etc.

 

[steveo3002]

yeah well imo its not at all suited to what you want

2k clear stands up to heat well

 

[Weldinator]

Ill have to think of something else, unless i use a little 2k lacquer holding my breath when quickly spraying it as its a very small area.

 

[Chipper]

If you already 1k'd it, why not do the obvious thing and 1k clear it. If you can't/don't use 2k.
Re heat, putting something else ontop of stonechip and 1k isn't going to make them stand heat any better.

 

[steveo3002]

yeah thats true..the stonechip will melt anyway

how about a heatsheild ?

 

[Weldinator]

Yeah your right, i think ill try using/cutting off some of the large heat shield i already have and modify it to fit somehow. The gap is about 6 inch opened up between the shields.

Can someone link me a place that sells very good quality heat resistant shield tape, so i can trim the edges etc ?