Bosch nibbler 1530.1

[fenman]

Hi all looking for a punch for my nibbler the ones on line don't have the captive nut. The nail in pic is 4inch for scale TIA

 

[mike 109444]

As a temp fix till you get one you could grind the corner back to a sharp edge where arrowed. That's what I did until I got a replacement (my Makita one did not have the captive nut)

 

[fenman]

As a temp fix till you get one you could grind the corner back to a sharp edge where arrowed. That's what I did until I got a replacement (my Makita one did not have the captive nut)

]Thanks Mike will give it a go

 

[zzr1200]

Fenman, I have a Bosch nibbler (not sure of the model) but when i replaced the die pin it didn't come with a nut, but it was an extremely tight fit through the nut, worth checking.

 

[fenman]

Fenman, I have a Bosch nibbler (not sure of the model) but when i replaced the die pin it didn't come with a nut, but it was an extremely tight fit through the nut, worth checking.

Will do Thanks

 

[fenman]

Fenman, I have a Bosch nibbler (not sure of the model) but when i replaced the die pin it didn't come with a nut, but it was an extremely tight fit through the nut, worth checking.

Big thumbs up tapped it with BFH and out it came can now order new one

 

[fenman]

As a temp fix till you get one you could grind the corner back to a sharp edge where arrowed. That's what I did until I got a replacement (my Makita one did not have the captive nut)

tried it Mike still not cutting thanks anyway