Bravo 2020m wont start

[coldair]

Hi there
I have Cebora Bravo 2020/m about 4 years old and done very little work
but tonight swiched it on & nothing would happen when i pulled the trigger so i checked for continuity at wire feed cable end & it was ok i removed side cover to check for slack wires as i had just pulled welder over some ruff ground all looked ok i noticed that there is a yellow light on front pannel it is on i think it is related to a thermostat some where but cant remember if it should be on
any help welcome

 

[Robotstar5]

Sounds like the thermal overheat lamp, look for a device with a couple of wires on mounted on the rectifier heatsink (Aluminium plates) you may find one has fell off during the rough handling.

...and welcome to the forum.

 

[coldair]

thanks for the reply went out to have a look at that & would like to say that that was the problem but being honest i have to admit that i discovered a safety micro switch on the wire feed side door which must have ratteled open when i was moveing it over the ruff ground
anyway glad i found this site will no doubt be asking questions in the future

 

[Robotstar5]

Thanks for letting us know, easy fix at no cost - result