Hello
I have a Bridgeport milling machine (I guess it's UK made) which it's power feed doesn't work. from what I've learnt so far - the power feed unit is 6-F model but it's not that simple (at least, not to me) I've obtained the American version of the manual of the machine and when I compared it to the control board - it seems that it's not the same. the British control board is made by a company called Erskine systems and the feed motor made by Fracmo (pics attached). I hope that you can help me out by telling me where can I find the schematic diagram of the control board. the fault is that there is no response from the feed motor when I engage it, not even by pressing the green "rapid" push button. of coarse I've checked and the supply voltage to the control board is there (the red & brown wires on the right side of the connector).
Thanx.
I have a Bridgeport milling machine (I guess it's UK made) which it's power feed doesn't work. from what I've learnt so far - the power feed unit is 6-F model but it's not that simple (at least, not to me) I've obtained the American version of the manual of the machine and when I compared it to the control board - it seems that it's not the same. the British control board is made by a company called Erskine systems and the feed motor made by Fracmo (pics attached). I hope that you can help me out by telling me where can I find the schematic diagram of the control board. the fault is that there is no response from the feed motor when I engage it, not even by pressing the green "rapid" push button. of coarse I've checked and the supply voltage to the control board is there (the red & brown wires on the right side of the connector).
Thanx.
