schrimy
New Member
- Messages
- 2
Hello to you all.
I have a 'project' broom wade compressor driven by a 10hp Briggs Stratton petrol engine. The Briggs is nearly done just waiting for some spares. The compressor is 24cfm and from 1979. It is in good nick but I thought that I would give it an once-over and a repaint. I have managed to get some new decompression valves, and thought it might take a look at the inlet valves whilst it was on my bench. I can get the cover off, with the three-pronged lifting things on, but cannot see how to get the valves out of the head?
Any Ideas?
Thanks.
Chris
I have a 'project' broom wade compressor driven by a 10hp Briggs Stratton petrol engine. The Briggs is nearly done just waiting for some spares. The compressor is 24cfm and from 1979. It is in good nick but I thought that I would give it an once-over and a repaint. I have managed to get some new decompression valves, and thought it might take a look at the inlet valves whilst it was on my bench. I can get the cover off, with the three-pronged lifting things on, but cannot see how to get the valves out of the head?
Any Ideas?
Thanks.
Chris
