hi all,
a project I am going to be undertaking will involve me cutting with an angle grinder and arc welding a car/van axle. Its not going to be put under a vehicle or again that involves a human or animal don't worry.
its about 50mm square steel bar
whats the best approach, what rods should I use
rods Im not sure on
this is the approach I was thinking of when welding it
I am guessing to weld it correctly bevel it back 5mm each side to give a 10mm gap and plenty space to fill. Then pass after pass after pass to fill the gap with a number 8 rod?
a project I am going to be undertaking will involve me cutting with an angle grinder and arc welding a car/van axle. Its not going to be put under a vehicle or again that involves a human or animal don't worry.
its about 50mm square steel bar
whats the best approach, what rods should I use
rods Im not sure on
this is the approach I was thinking of when welding it
I am guessing to weld it correctly bevel it back 5mm each side to give a 10mm gap and plenty space to fill. Then pass after pass after pass to fill the gap with a number 8 rod?