- Messages
- 22,271
- Location
- Birmingham
Does anyone recognise this model of fill valve please as I would like to replace the seal which is leaking.
- Thread starter Robotstar5
- Start date
Blobber
Member
- Messages
- 2,549
- Location
- lincolnshire
droopsnoot
Member
- Messages
- 1,100
- Location
- South Cheshire, UK
Is this causing it to dribble into the pan, leading to it re-filling every so often? Mine (also a SIAMP) is doing similar, and I keep putting off fixing it. I've seen a video showing how to clean the washer, but when I tried to remove the fill valve by twisting it, I couldn't get it to move. I've since seen another video that suggests I need to push down and turn, and I'll have to try it soon.
Kayos
Gone......
- Messages
- 9,184
- Location
- Yorkshire
That's called a rip it out and fit a new one
- Messages
- 14,521
- Location
- UK
Toilet problems (Not that sort)
Another one for the oracle! The bog fills up when it is flushed but then keeps hissing at a high pitch as water is still passing through the little inlet next to the nut where my finger is. Had a fiddle and there is nothing blocking it etc. Its all fantastic plastic so it might be easier to...
www.mig-welding.co.uk
A regular job in our household
angellonewolf
Member
- Messages
- 8,471
- Location
- bristol england
agree swap it out not a bad job to do if you got a isolator valve easy one
turn off water flush toilet use sponge for the last bits water unscrew replace and done and forget about it for another 10 years dont penny pinch on the replacement go as above and the next time you do it
its off water pull the slip colier and pull out and replace top part 5 min job
A £4.00 spend or a £16.00?
Kayos
Gone......
- Messages
- 9,184
- Location
- Yorkshire
Yes, and never ever ever have to fit another stupid pointless annoying washer ever again
Money well spent
Pigeon_Droppings2
Member
- Messages
- 5,953
- Location
- london
That looks like the same thing that broke on my fancy cold water tank fill...all I did was replace the rubber seal.
