Hi, I have just bought a second hand Eland mig 160 welding plant and the 4 position torch setting switch which is fixed to a circuit board is faulty. The only setting that works is the first setting on the switch, so you have to press the torch trigger to start welding and then press it again to stop welding. Any other switch posistion and the trigger starts the welding and it wont stop untill you turn the plant off.
I am after a circuit board if anybody knows where I can get one from.
I will get a picture and P/N this evening.
The trigger switch is the second switch from the top on its own in the picture.
I am after a circuit board if anybody knows where I can get one from.
I will get a picture and P/N this evening.
The trigger switch is the second switch from the top on its own in the picture.
