Chippie Member Messages 855 Location Newcastle upon Tyne, UK Dec 26, 2022 #1 I am changing the magnetic base on my Ender 3, just pulled off the magnetic adhesive plate, underneath it was a clear film of plastic…I pulled that off too….. should I have left it attached?
I am changing the magnetic base on my Ender 3, just pulled off the magnetic adhesive plate, underneath it was a clear film of plastic…I pulled that off too….. should I have left it attached?
M m_c Member Messages 3,073 Location East Lothian Dec 26, 2022 #2 I can't say I've ever noticed a clear film of plastic... I stripped both my enders back to the bare aluminium when I converted them to magnetic flexible steel plates
I can't say I've ever noticed a clear film of plastic... I stripped both my enders back to the bare aluminium when I converted them to magnetic flexible steel plates
Chippie Member Messages 855 Location Newcastle upon Tyne, UK Dec 26, 2022 #3 Thanks, just checked, the new mag plate ‘base’ completely covers the ally heat bed, so I’m happy….
