Just like to say hello to everyone and also ask a question. I plan on starting a mobile rig and was wonder what machines to go with . I was told a tig/stick combo and a good medium of the line mig/fluxcore.any advice from you pro's would be greatful.i am not to bright on different machines I just run them.lol. Thanks to you all !
- Thread starter levis
- Start date
shenion
Tool Pack Rat
- Messages
- 7,586
- Location
- Stone Mountain, GA USA
Depends on your budget. Most seem to spend $10-$20k for a fully equipped mobile rig.
Most mobile welders will do MIG, TIG and stick in one machine (have to add wire feeder for MIG and TIG torch.)
If it were me, I'd look at something like a Ranger 250.
Welcome to the forums
Most mobile welders will do MIG, TIG and stick in one machine (have to add wire feeder for MIG and TIG torch.)
If it were me, I'd look at something like a Ranger 250.
Welcome to the forums
Rig Pig
Member
- Messages
- 3,742
- Location
- Narrwich! U.K.
Hi Shenion,
Just been looking at your DIY welder what a brilliant idea! I have been offered a Miller Roughneck, old and with bits missing and I started thinking about fitting your control board in place of the regulator to give me the option of fitting a rectifier and using it for MIG + DC welding. Do you think that the board would be able to drive the Miller?
Thanks
Jeremy
Just been looking at your DIY welder what a brilliant idea! I have been offered a Miller Roughneck, old and with bits missing and I started thinking about fitting your control board in place of the regulator to give me the option of fitting a rectifier and using it for MIG + DC welding. Do you think that the board would be able to drive the Miller?
Thanks
Jeremy
