roller table for bandsaw

[powderblast]

hi has any one had any experience with these roller tables for use on a bandsaw, are they strong enough?

 

[brightspark]

hi has any had any experience with these roller tables for use on a bandsaw, are they strong enough?

yes as long as your not cutting tree trunks up or massive rsj

 

[powderblast]

yes as long as your not cutting tree trunks up or massive rsj

just unsure how strong the rollers are individually say if you drop a length of box section on one would it dent

 

[Brad93]

I’ve got loads of them. Spend the time getting them level and fix the legs with some cross braces

 

[powderblast]

I’ve got loads of them. Spend the time getting them level and fix the legs with some cross braces

i did end up buying them i bought two 3mtr ones the one in the pic and i was unsure about them but after levelling, straighten and bolting down they are solid to be honest i will post a pic of them i need to build and fit a stop guide on the out feed table also the guy had a Goliath flat bar bender which i bought it just has not got the vise to clamp the steel down but works fine by using a g clamp, not sure how much its worth as im thinking of selling that one and trying to buy one complete