runs in 2k clear coat

[d c]

first time spraying a clear coat and i got me a couple of runs on the first coat of the clear coat despite me telling myself to go easy .
is it best to wet sand them back at this stage when dry then apply more coats of clear or apply a few more coats and deal with the runs at the end by wet sanding and buffing?
one of the runs is at the bottom of the B pillar on the door, between the handle and door edge. the other is below the window area on a curved surface of the door skin.

 

[pedrobedro]

Shave it down with the edge of a razor blade before it sets really hard then give it some more.

 

[d c]

thanks for the tip.
i got the worst off with a blade but i think it will need some wet sanding when cured a bit more before i go any further.

 

[langy]

You can use a Run razor or the old method of applying a few layers of tape to both ends of the blade and then shaving.