Gallowaysteelart
New Member
- Messages
- 12
- Location
- Newton Stewart
This is my latest creation formed from 1.2 mm stainless steel
- Thread starter Gallowaysteelart
- Start date
Barking Mat
Cuddler of hedgehogs.
- Messages
- 12,917
- Location
- France, Brittany.
I like, but you going to flap disk those welds ?
badabec
Forum Supporter
- Messages
- 1,929
- Location
- Essex UK
Only the wings
Gallowaysteelart
New Member
- Messages
- 12
- Location
- Newton Stewart
Aye its got another 2 days in it yet. Got about 4 hours of flap discing to do
Gallowaysteelart
New Member
- Messages
- 12
- Location
- Newton Stewart
Onthespotwelding
Member
- Messages
- 526
- Location
- Kent - England
chunkolini
celebrity artiste
- Messages
- 9,456
- Location
- Swansea
Nice, a good sense of movement
One thought: more practice on the plasma cutting would give tidier edges.
Try supporting the torch by using your left hand as a steady and sliding it along the surface. Nozzle is OK just barely touching the surface.
Do a practice run before making the cut.
Tuck the excess hose out of the way, i usually have it under my arm.
It's about breathing slowly and relaxing..
I do say out loud ' chil out you tense **Language**er' as I'm setting up.
Sounds corny but it's almost like a meditation. Go watch the karate kid films.
A bit of freehand work below
One thought: more practice on the plasma cutting would give tidier edges.
Try supporting the torch by using your left hand as a steady and sliding it along the surface. Nozzle is OK just barely touching the surface.
Do a practice run before making the cut.
Tuck the excess hose out of the way, i usually have it under my arm.
It's about breathing slowly and relaxing..
I do say out loud ' chil out you tense **Language**er' as I'm setting up.
Sounds corny but it's almost like a meditation. Go watch the karate kid films.
A bit of freehand work below
