tripod hoist stand constructive advice

[u facciolu]

hello I have to build a tripod hoist to perform hard labor in the countryside as I proceed?They size as poles and bracket? that use material, the dimensions are 14 feet under hook a ton of flow

 

[Forestryengineeringservic]

If this is going to be used for buisness use it will have to be loler tested to alow itto be legally used

 

[Sarto]

Hi, the last is yours?
Or is it only an example?

 

[captain-destructo]

depending on ground conditions you may want to add holes in the feet so it can be pegged down to stop the feet sliping out and everything coming crashing down

 

[Robotstar5]

If this is going to be used for buisness use it will have to be loler tested to alow itto be legally used

Do they have LOLER in Italy?

 

[brokenbiker]

If it's being used in the country side I would put larger foot pads on each leg to spread the load and stop sinking, and as said put holes in each on to get some decent pegs in there to hold it in place

 

[AndyStobbs]

As above with regard to legs spreading (don't) I would run chain between each leg.

 

[CompoSimmonite]

If you can get them in Italy then Acro's are ideal to use as the actual legs after cutting off the ends. Mine are made out of 48mm top with 60mm bottom. That means KeeKlamp fitting like this can be used for top leaving just the centre hub to be fabricated -

I'd use chain as well to stop legs separating.

 

[AndersK]

Do they have LOLER in Italy?

I believe all commercial lifting devices must have CE approval in the union.

 

[mtt.tr]

I just use 3 scaff poles. That's how I lifted my mill.