Ok so I think I count as an intermediate stick welder >500 rods and have a SIP T1400 arc which is so much better than my previous buzz box.
I'm doing a project to butt the end of 10mm square bar to the side face of 20mm square bar for outdoor sculptures and need to weld up all 4 faces probably using 6013. About 30 joins per item. Steel will be new but working outdoors in a workshop area, Have done this ok with stick but spent quite a bit of time repositioning. Would another method be quicker (?mig) or am I good?
Thanks for any thoughts on this.
I'm doing a project to butt the end of 10mm square bar to the side face of 20mm square bar for outdoor sculptures and need to weld up all 4 faces probably using 6013. About 30 joins per item. Steel will be new but working outdoors in a workshop area, Have done this ok with stick but spent quite a bit of time repositioning. Would another method be quicker (?mig) or am I good?
Thanks for any thoughts on this.