Ive got one of those cheap "Germanese" plasma cutters. Havent used it for ages, and last time was just for rough cuts.
Got it out the other day and i cant get a decent cut out of it.
I am sure there was a post on here somewhere that had info about current pressures for different thicknesses but a cant find it.
I am cutting thin sheet steel, (recycling appliance sides) how should i set it up?
Al
Got it out the other day and i cant get a decent cut out of it.
I am sure there was a post on here somewhere that had info about current pressures for different thicknesses but a cant find it.
I am cutting thin sheet steel, (recycling appliance sides) how should i set it up?
Al