skotl
Forum Supporter
- Messages
- 9,685
- Location
- Edinburgh, UK
Only had my 3D printer for a few weeks. Used it a handful of times with maybe a week in between goes - both times, the filament has snapped where it enters the feeder.
I know there can be problems with moisture (it's in a bedroom, not outside) but I'd have thought that dryer... anything... gets more brittle rather than the other way round.
Has anyone else had this problem?
I know there can be problems with moisture (it's in a bedroom, not outside) but I'd have thought that dryer... anything... gets more brittle rather than the other way round.
Has anyone else had this problem?