Misery dog
New Member
- Messages
- 24
- Location
- Sk86bs
cant find a top roller for a sips migmate 150 welder anywhere can anyone guide me to the right place for this ,its just plain face with race bearings in it.
sizes are inner 9.1 outer 23.9 width 7.0 but still cant find one
It says on that page it's 8mm ID 23mm OD 8mm wide.
A 608 bearing is 8x22x7..........................could be close enough for an SIP
If you PM me with your details I'm pretty sure I have a spare or two and can send you one.
John
hi john , i measured it and its inner 9.1 outer 23.9 width 7.0 mm the 9.1 is pretty crucial as its a tight fit,If you PM me with your details I'm pretty sure I have a spare or two and can send you one.
John
thanks John what i have noticed is the bearings seam shot it wobbles just like when you test a car bearing, so that wont help.The roller is the right size and has the central shaft in it already so I've left it there. I'll get it posted as soon as I can.
John
Haven't heard from you? Did the roller arrive OK?
John
and better qualityOne here but i'm sure it would be £20 cheaper if you knew the size.