Does anyone know where I can get these?
Do you not have a lathe man?
This company is not the only Bijur supplier but many companies offer free postage over a minimum order, which should if you look at all you need should not be a problem.Just going through the Bijur lube unit and a few of the Metering units are not working , they are normally difficult to find with 5/16 thread but this site does them cheap £12 postage is cheeky though !
FJB Flow Units
Official Distributor and stockist of Bijur. Available online and instore. Meter units FSA, FSB, FT, FB, FJB, FJD, FKA, FKB, CSA, CT, CJB, CJD, CKA, CKB. AJB, ASA. Also avaiLble full range, TM-1 PUMPS, TM-5, Surefire pumps and much more.lubetec.co.uk
Google lathe handle, there are some on Ebay.Does anyone know where i can get these ? ive googled but not sure what to call them , thread is 5/16" two have been snapped off
View attachment 445136
I have never found any this cheap postage is cheeky though sods law i was in Leeds 2 weeks ago !!This company is not the only Bijur supplier but many companies offer free postage over a minimum order, which should if you look at all you need should not be a problem.
nothing the same though i'll make something similar on the lathe until i can justify £25 for a real one (never probably)Google lathe handle, there are some on Ebay.
If you don't buy a handle you may be tempted away from manual to cnc. Read about what happens if you succumb to temptation.nothing the same though i'll make something similar on the lathe until i can justify £25 for a real one (never probably)
I ordered some 316 stainless Jubilee clips and 316 capscrews from westfield fasteners (brilliant company) £40 min order, only to find out i had ordered one less bolt than i needed, so i ended up buying more clips i will need for another job. The moral of the story is to make sure you order what you need in one lot.I have never found any this cheap postage is cheeky though sods law i was in Leeds 2 weeks ago !!
I looked, much money spent, better to buy a used one.If you don't buy a handle you may be tempted away from manual to cnc. Read about what happens if you succumb to temptation.
CONVERSION: Bridgeport Manual to CNC conversion...
Anyone here converted a manual Bridgeport mill to CNC? After building my plasma table and my mini-mill, both of which are working lovely, I WANT MORE CNC ;) ;) My old 9x48 Bridgeport is looking for some love but is it worth it? It would need a ball-screw conversion kit, these are...www.mycncuk.com