W.olly
Member
- Messages
- 3,624
- Location
- Radcliffe, Manchester
Hi all been doing a bit of welding for a change. not done much for a good while.
Now the other day it was all ok, well still is but for this that i noticed this today.
The red light comes on for a short time, well seconds, then the Arc mode works.
Is this saying there is a slight fault as in owners manual (as below copied from manual ) or just switching over from Mig to Arc ?
6. Warning LED. This warning light will come on under these situations to warn of either low input voltage has been sensed or there is an internal fault with machine, check wiring connections, if still illuminated contact R-Tech support department.
Now the other day it was all ok, well still is but for this that i noticed this today.
The red light comes on for a short time, well seconds, then the Arc mode works.
Is this saying there is a slight fault as in owners manual (as below copied from manual ) or just switching over from Mig to Arc ?
6. Warning LED. This warning light will come on under these situations to warn of either low input voltage has been sensed or there is an internal fault with machine, check wiring connections, if still illuminated contact R-Tech support department.