kzsmooth31
New Member
- Messages
- 8
- Location
- USA
Hi Everyone! I have a Rebel 215ic EMP. The machine powers up, and on the user interface I can scroll through all the options. However, when I select any weld process, the unit just freeze up and I have to turn the machine off then on again. I tried to do a factory reset from the user interface options, but the unit still freezes and I get “Err 000.” I suspect it may be a bad control board because I am not getting a version number under “Firmware Information” as the picture below shows. Also, when ordering and replacing the user interface or control board, do they come with the correct firmware already loaded or are they just blank boards that require the firmware to be loaded by a technician. Thanks for any help!