Dogmatix
New Member
- Messages
- 28
- Location
- Saline, Scotland
My Sealey SuperMig 180/1welder's circuit board appears to be faulty.
The wire feed speed doesn't increase when the power setting is increased as I would expect it too.
Is there a known common fault anyone is aware of ie; blown power transistor or something like that? I could repair it myself if that is the case.
Does anyone on here do repairs to these?
There's a couple of sellers on Ebay advertising repairs for welder PCB's, one at £45 and the other at £79. Can anyone recommend a either. It's tempting just to go for the cheapest but I want a quality repair done.
The wire feed speed doesn't increase when the power setting is increased as I would expect it too.
Is there a known common fault anyone is aware of ie; blown power transistor or something like that? I could repair it myself if that is the case.
Does anyone on here do repairs to these?
There's a couple of sellers on Ebay advertising repairs for welder PCB's, one at £45 and the other at £79. Can anyone recommend a either. It's tempting just to go for the cheapest but I want a quality repair done.