sardine Member Messages 3,563 Location Buckinghamshire Oct 25, 2023 #1 I'm putting together a dc set up for sheet 1 - 3 mm, what shrouds should I get ? What size filler rods should i stock up on ? What size TIG brazing rods to use on 1 mm sheet ? I have everything else ready to go.
I'm putting together a dc set up for sheet 1 - 3 mm, what shrouds should I get ? What size filler rods should i stock up on ? What size TIG brazing rods to use on 1 mm sheet ? I have everything else ready to go.
AKN Master of Disaster Messages 422 Location MK Buckinghamshire GB Oct 25, 2023 #2 If you haven’t already take a look at:- https://www.mig-welding.co.uk/tig-calculator.htm The setup page says No. 7 shroud for most except fillet welds which is No. 4.
If you haven’t already take a look at:- https://www.mig-welding.co.uk/tig-calculator.htm The setup page says No. 7 shroud for most except fillet welds which is No. 4.
Shox Dr Chief Engineer to Carlos Fandango Messages 17,987 Location East Yorkshire Oct 25, 2023 #3 No6 Shroud 1.6mm Tungsten 0.8-1.6 mm rods