premmington
Member
- Messages
- 5,721
- Location
- Norfolk
Mine is a 240v - been pleased with it - been a good welding set.
At the time I could not "go to a Fronious" - and I am glad I did'nt now.
- Thread starter Mick Annick
- Start date
Mine is a 240v - been pleased with it - been a good welding set.
At the time I could not "go to a Fronious" - and I am glad I did'nt now.
premmington
Member
- Messages
- 5,721
- Location
- Norfolk
Means line boring it twice - the welding is the easy bit. The line boring is the time consuming part.
Plus if you have done any amount of - bore welding - you will know half of half the rods gets wasted - due to simple access issues.
You tripping over - long stubs on the floor. So a box is not really a box - if you know what I trying to say.
------------
Been doing a lot of digger pins of late - until you blow the pin out - you don't know what you got - had this not been on site - and at workshop - I may have choosen the bush route as suggested... Needs must type of call. Plus you don't really know - what size to make the bush - to get it near parralel for the second inner cut - so you end up back and forth to the workshop like a "robbers dog".
