anyone know where to get oil/hydraulic fittings that look like this

[MoreWellie]

Not a DIN fitting is it?

I believe that 12s connectors are part of the Din series, same as the connectors I bought and pictured in post 5 which would make the answer No unfortunately

 

[Hilltech Hyds Dermot]

can you get any hydraulic shop to switch the hose tails from metric to bsp ,the bsp will have a 60dg cone and will seal mechanically on the cooler, some forktrucks use a 22mm fitting that has to have the bsp cone with metric thread,

 

[MoreWellie]

Still trying to get the right connectors but will bear that in mind to try as I already have some bsp cone fittings of a similar size

Welcome to the forum!

 

[Hilltech Hyds Dermot]

I will have a look tomorrow to see if I take the 12s hose tail out will 3/8 bsp fit through the 20-1.5 nut
thank you
been using this forum with a while and I said I better start to give something back its a very helpful forum 90% of tips or tricks are real life experiences.

 

[morph]

I will have a look tomorrow to see if I take the 12s hose tail out will 3/8 bsp fit through the 20-1.5 nut
thank you
been using this forum with a while and I said I better start to give something back its a very helpful forum 90% of tips or tricks are real life experiences.

that’s good to know, I’ve been doing hydraulics at a large ag contractors for 5 years now and thought I’d seen a lot but having to mix bsp and metric on the same hosetail is a new one on me!!! What a nightmare!!