Myford ML7 quick change toolpost options

CRB · Feb 3, 2015

CRB said:
The one I have, from where I do not remember, is a four-way, which I see now is a bit of a waste. You can only use one at a time, and spinning the post around without a detente is a waste too.

I like DoubleBoosts' because it has a big lever and height adjusters. This may be due to scale, larger lathe.

There is also another I came across just before seeing one on here. Big pennies though.
http://www.rotagriponline.com/index...art&page=shop.browse&category_id=61&Itemid=29

Remembered, but they appear to be sold out, and it is now only a two-way.

http://www.rhrtools.co.uk/shop2/index.php?main_page=product_info&products_id=443

mr_splatter · Feb 3, 2015

One of my RDG one's is a bit tight on the block and needs a tap to get down so the tolerances must be different. Maybe I was unlucky on this one. The others are fine.

brightspark · Feb 3, 2015

mr_splatter said:
One of my RDG one's is a bit tight on the block and needs a tap to get down so the tolerances must be different. Maybe I was unlucky on this one. The others are fine.

thats good then if they suposed to save u time setting up :whistle:

Ali · Aug 3, 2024

Does anyone use one of these?

Model Engineering and engineering tools online from RDG Tools Ltd Home Page (Engineering Tools) Tel 01422 885069 /884605

5056685102817

www.rdgtools.co.uk

Interested in any limitations compared to the Dickson type.

Myford ML7 quick change toolpost options

CRB

Member

mr_splatter

Member

brightspark

Member

Ali

Member

Model Engineering and engineering tools online from RDG Tools Ltd Home Page (Engineering Tools) Tel 01422 885069 /884605