What is this thread?

[Kayos]

I hate it, its really why i hate plumbing coming out with loads of different fittings and non fit.

I fitted some Italian radiators, I thought they were hideous.

struggled fitting the supplied valves until I actually looked at them, M24 left hand thread. Mental note made to block customer if they needed any repairs in the future

 

[8ob]

However, I am quite sure that 7/8" is NOT the pitch of the thread as the listing states.

Lost in the translation . Seems a bit dear for hoseloc, I know its a bit oddball but I would have thought there must be a cheap plastic alternative somewhere

Bob

 

[Parm]

I hate it, its really why i hate plumbing coming out with loads of different fittings and non fit.

Lol, old boy is a retired engineer, any excuse to take some measuring gear to the shops.

Drives mum nuts

 

[Parm]

Lol, old boy is a retired engineer, any excuse to take some measuring gear to the shops.

Drives mum nuts

She punishes him by taking him to the knitting and fabric shops

 

[pressbrake1]

That’s when cnc is handy when you need to make a nonsense thread that defines best as metric like 2.34 pitch or whatever it was which I came across on a old French truck

 

[mtt.tr]

That’s when cnc is handy when you need to make a nonsense thread that defines best as metric like 2.34 pitch or whatever it was which I came across on a old French truck

Thats Typical for the French

 

[Barking Mat]

We've got an ENO, gas three burner hot plate, at work, the fitting supplied are left handed unheard of gas fittings, 23 euros a piece, with 53 euros carriage!

Bastardds

 

[Guzrik]

https://www.gewinde-normen.de/

If it is not on this site it is imho usually better to just fabricate what you need .

 

[Guzrik]

Gascilinder connections are different standards even between countrys. Combustible gasses always (?) lefthand thread.

 

[Turbo]

Bloody annoying isn’t it.
Anyone got a link to a tap that will definitely work?

Its got to be ¾”BSP on the inlet (back) But the outlet can be ½” BSP as long as I can get a hozelock connector on to it.

Is this for the IBC tank for your mate? As I advised before, go for a 3/4" full bore ball valve, there is a hoselock 3/4" fitting that will screw into it with the QRC male on the other end.

 

[Stueeee]

https://www.gewinde-normen.de/

If it is not on this site it is imho usually better to just fabricate what you need .

Thanks for posting this up, lost the bookmark I had before when a hard disk failed. This site is just the thing if you are sufficiently unfortunate to be asked to produce a job with something like a Hamann Patronen Thread on it

 

[Guzrik]

I would expect there would be a nice app, male, female, diameter, pitch, angle and a thread comes out.
Does anyone know.