Parweld XTM 211Di multiprocess machine. An overview.

[Jbo2231]

Slight aside but just bought one of these to replace my Cifes mig - anyone got an English user manual for it?

I can find every language but and Parweld UK don't even list the machine on their website yet.

On the other hand everything looks very well put together, good quality torches, even the arc welding clamps are very good quality with machined/vee'd out solid copper clamping blocks. I can't fault it if it performs as well as it looks screwed together.

edit: Got one, thanks.

Sorry, only just seen this. Might be worth uploading it if you can? I cant remember where mine is and someone else might run in to the same issue

 

[PhillipM]

Good point:

 

[PhillipM]

I'll keep it to this thread but does anyone have a 0.6/0.8mm wire feed roll or a source for one anywhere? They're listed, but none of my local places have one in stock, I even got in touch with Parweld themselves and *they* don't have one in stock either.

 

[Agroshield]

I'll keep it to this thread but does anyone have a 0.6/0.8mm wire feed roll or a source for one anywhere?

What you might have to do is to remove the roller you have and photograph and measure it. Maybe even take it with you in person to a good welding store. I do not think that every single manufacturer would make a roller proprietary to his or her particular brand.

 

[PhillipM]

Yeah, one of the places had some chinese clones that were close enough to fit but the quality looked crap, they were just cast pieces - I'm not convinced they were actually round!

 

[PhillipM]

Just an update a little googling shows the drive system is the same as the ESAB/SAF/etc units, just bolted in, so the rollers for those fit (as does the 2wd roller conversion!)