Heat it with a blow torch, drop your trousers and it is ready to roast yer nuts?Still working my way through HPS's freebie horse shoe's . Thought I would stick some bit's of scrap stuff to it and bodge a much needed Christmas 'cooking' implement. Any ideas?
View attachment 424294
That was too easy ! Well sussed.Heat it with a blow torch, drop your trousers and it is ready to roast yer nuts?
Looks great but I hate to think what would happen if somone fell on the stairs, if it shattered, some of the peices could be very large impalement hazardsAlso did this over the weekend, ripped out the old bannister etc from stairs and landing, this was part way through.
View attachment 424131
This is the stage I am at, got a hand from my pal to fit the glass,
View attachment 424133View attachment 424132
It is hardened so will break into small rounded pieces like an old fashioned windscreen did.Looks great but I hate to think what would happen if somone fell on the stairs, if it shattered, some of the peices could be very large impalement hazards
I have slipped on stairs before.
I was just about to reply to this but I've been beaten to it , worst case a bad bit of glass rash . You could throw a 2lb hammer at it and 99 times out of a 100 it'll bounce of .Looks great but I hate to think what would happen if somone fell on the stairs, if it shattered, some of the peices could be very large impalement hazards
I have slipped on stairs before.
I don't need a lesson, my LR series went on the A13, pushed it out whilst driving and pulled over when i could.Like this.
Had toughened laminated glass (bullet proof) on the doors of my Chiron, it exploded and I thought it was a shotgun had gone off inside my workshop I will see if I can find a pic.I don't need a lesson, my LR series went on the A13, pushed it out whilst driving and pulled over when i could.
Oh it was absolutely lashing it down. Its laminated now
I don't need a lesson,
and 99 times out of a 100 it'll bounce of .
I was being facetiousI believe that video was for Kram's benefit.
I was being facetious
Yeah that'll do it!Here you go, seemingly it was caused due to when hardening the glass it has a slight bow to it and if when they laminate it they don't have the bow of the two sheets the same way then it causes stress and will often just explode, all I know is it was loud and I nearly crapped myself, I would have if I was closer
View attachment 424324
Also did this over the weekend, ripped out the old bannister etc from stairs and landing, this was part way through.
View attachment 424131
This is the stage I am at, got a hand from my pal to fit the glass,
View attachment 424133View attachment 424132
but each box will hold a project that would normally block my bench up
Testing the baby saw with charged (but old) Lidl 4Ah battery. 9-10" log, it gets about 8 cuts maximum, slows a lot whe