Great British bake off beckoning....
You should have used the mill for comic value, dewalt comes in a good second place, excellent vid.
. I run mine at again from memory about 35.5v which equates to about 380amps. I initially got this machine to do alli, which it did OK, which isn't as good as the Fronius I use now, but good enough to get by. I have two as the importer that was selling them was getting newer models and they wanted to get rid of old stock, so I got the second as a spare. They haven't done much work till recently (about 2years) they have been used to do playground equipment, the bigger thicker stuff. So far cannot complain with their operation as they have been fit for purpose
The main issue is that somebody got his fingers on that previously.I in fact have two of these. One was exactly the same as shown, but was later changed over to the newer front panel, which is much better to live with. I think from memory this above machine is version 'K', which from also memory was the first model. These machines were new about 21 years ago. I have one running 1.2mm solid wire with a water cooled MB36 torch. This machine is rated for 350amps, but it will output 380amps at full tilt
If your yards are like some here, you will get less money, as it is mixed copper for that bundle.
Yes. This is on next task here.
think thats what happens when u try and say breeexit
). Following a conversation on another forum, I thought I'd do an experiment and see how thin I could successfully machine a bit of wood using my thicknesser (someone had commented that they wouldn't dare go down as low as 2 mm). 
